You will be asked two (2) times if you would like to erase the memory. After the second time, the controller will erase
all data in the active memory system (not the storage/snapshot area), and will load default settings to all the databases
(Preset, Song, Set-List, Pages, Sysex Messages, Global Settings, etc…)
IT IS RECOMMENDED THAT YOU POWER CYCLE AFTER AN ERASE.
If you are making a MIDI based backup, then load your MIDI software. Prepare it to receive Sysex dump. When the
software is ready, then press to begin the FULL MIDI DUMP. Store the file in a safe location as it is your backup
of the entire controller’s active memory information. If a system restore is required, this file will be used. This utility function
will transmit the information out of the MIDI-OUT port. Make sure the computer’s MIDI input cable is connected to the MIDI-
OUT connector of the controller.
To Next Page
Loading...