Remote
Control
Dip Switch
5.
6. Replace battery cover on the remote control with
previously removed screw by screwdriver. (Figure 6)
To set the remote code same positions as the
receiver with a small screwdriver or ball point pen
(neither included), slide dip switches firmly up or
down. (Figure 5)
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference from
or to other remote units, simply change the
combination code in the remote and receiver.
NOTE: Factory setting is all up. Do not use this
position.
Figure 5
• Sleep Timer:
The fan and light will turn off after 1 hour.
The fan and light will turn off after 3 hours.
The fan and light will turn off after 6 hours.
7. Remote functions: (Figure 7)
• Indicator LED light: fan speed and light
dimmer indicator
• Fan Speed:
• button: Tap once to turn off the fan. Press and
hold this button for 5 seconds to turn on or turn off
the buzzer.
• Light button: Turn ON\OFF the light.
Turn on fan and turn speed up.
Turn on fan and turn speed down.
Increase light output level.
Decrease light output level.
• Home Away: Tap this button, the light will
blink twice signaling this feature is on; the fan
will turn off and the light will randomly turn on
and off while you are away. Pressing any button
will cancel the feature.
• Fresh Air: Fan speed will modulate to
simulate a natural breeze.
• Safe Exit: Tap once, the light will blink once;
fan and light will turn off after 1 minute. Pressing
any button will cancel this feature.
Figure 7
• Reverse button:
Summer- The fan runs counterclockwise.
Airflow will provide a downward cooling breeze.
Winter- The fan runs clockwise. Airflow will force
warm air downward without a noticeable breeze.
In order to reverse the direction of the fan, the fan
must be running.
Figure 6
How to Operate Your Ceiling Fan (continued)
15
To Next Page
Loading...
Need help?
General
