87
MAINTENANCE
IT
EN
DE
FR
Headlight adjustment
– To check the correct orientation of the front light beam,
place the vehicle at 10 m (32.8 ft) away from a vertical wall,
making sure that the ground is level.
– Turn on the low beam, sit on the vehicle, and check that
the light beam projected onto the wall is slightly below
the horizontal straight line of the projector (about 9/10 of
the total height).
– To carry out the vertical adjustment of the light beam,
position the vehicle in running position.
– Loosen the screws “1” and “2” securing the headlight.
– Turn the adjustment screw “3”; tighten it to raise the
beam, unscrew it to lower it.
– Check again the correct orientation of the light beam.
– Tighten screws “1” and “2” to secure the headlight.
3
1 2
To Next Page
Loading...
