Fargo CUPS HDP5000 - Selecting Resin Dither; Following the Dye-Sub Intensity Procedure

Selecting Resin Dither:
Select the appropriate dither method according to the type of image to be printed. (Note:
This option only affects those objects printed on the backside of a card with the resin black
Panel of a YMCK or YMCKK Print Ribbon. This is only enabled when using at least one K
panel and dual sided enabled, splitting one set of panels.)
Command Line
Usage
CUPS Option Description
ResinDither = graphics Resin Dither =
Optomized for
Graphics
This is a lower quality print.
ResinDither = photo Resin Dither =
Optomized for Photos
This is a higher quality print.
Following the Dye-Sub Intensity Procedure
Command Line
Usage
CUPS option Description
DyeSubIntensity=0
<-50 to 50>
Dye-Sub Intensity (YMC) = 0 1. Adjust the Dye-Sub Intensity
value higher to use more heat
when transferring dye-sub
colors to the card. (Note: This
will produce a darker, more
saturated image.)
2. Adjust the dye-sub Intensity
value lower to use less heat
when transferring dye-sub
colors to the card. (Note: This
will produce a lighter print.)
HDP5000 Cups (Linux & MAC OS) User Guide Rev1.1
15