© 2010 HID Global Corporation All rights reserved
DTC1000/DTC4000 Card Printer/Encoder User Guide (L001398, Revision 1.2)
32
Driver Installation Instructions
• Select “Install the Printer Driver” to start the Driver installation.
• Select the Fargo Workbench Utility Program to install this program.
• Select the Swift ID to install this program.
• Specific versions of Windows require Administrator rights.
• From the Printer & Faxes folder, open the Printing Preferences to setup the Driver after it has been
installed.
• Printing Preferences need to be setup after the Driver has been installed. Each TAB is shown below.
• Use the drop down arrows to select the correct options for each printing preference.
• To install Swift ID™ (Embedded Badging Application software), follow the Installaware Wizard
located on the Printer Driver CD.
• Enable Swift ID over a USB connection: This item will be checked if the Printer is setup to utilize
Swift ID via a USB connection.
o When this box is checked the Ethernet connection (if applicable) on the Printer will not be
operational.
o If this selection is not accessible, this is because the HID EEM Driver that Swift ID uses to
connect via a USB connection has not been installed.
o This Driver can be found on the installation CD or it can be down loaded from the HID
Global support page.
o The easiest method for enabling Swift ID is to un-install the Printer and its components and
go through the installation procedure and select that you would like to use the Swift ID
application.
To Next Page
Loading...
Need help?
General
