(!)
ATTENTION
(!)
Carefully inspect the load rigging.
Hook up the load, checking that it does not exceed the capacity indicated on the lifting
diagram specific to each load configuration.
Make sure that the lifted load is balanced.
(!) ATTENTION (!)
Avoid swinging the load above working and transit areas. Any hidden dan-
ger situation must be audibly alarmed.
Avoid swinging the load above the
control station. In cases where the load is too close, the crane must be operated
from the opposite side or with the radio-remote control (if fitted)
.
During the loading and unloading operations it is prohibited to leave the control sta-
tion or the control at a distance.
Activate the controls with slow and progressive movements
. Move the load with
the greatest caution, and avoid swingings and collisions. Avoid the rapid displace-
ments and the temporary stops, since they can cause the load swinging.
Do not rotate the crane before the load is lifted. Rotate slowly and with care
paying attention to the stability of the vehicle.
With vertical lift, on hydraulic and mechanical extension, rotate slowly in order to
avoid side-skidding.
(!)
ATTENTION (!)
Handle the wet or frozen load with the maximum attention: it exists the
skidding danger. It's obligatory to clean the load from the ice or the snow
before lifting.
When operating through a winch, lift the load vertically using the cable and
not the booms in order to avoid swinging the load.
The crane must be used exclusively to lift loads.
It is prohibited to unblock, hit, pull or drag the loads.
It is prohibited the lateral traction or the vehicles drawing.
(!)
ATTENTION (!)
Do not utilize the crane for pushpull (F), lateral (F) or sideways (F)
operations.
Crushing (F) or push (F) manoeuvres are not permitted.
Never operate the outriggers when the crane is loaded.
(!) ATTENTION (!)
The vehicle\crane must not be left unless the load is on the ground, the
booms of the crane (and of the hydraulic jib), are folded and laid on a solid
base and the power take-off is disengaged.
Do not move the vehicle when the crane is not in transport position.
Do not move the vehicle
with a load suspended on the crane.
(!)
ATTENTION (!)
Avoid working conditions which present danger for the operator and the per-
sons present in the action area of the crane, the outriggers or the load.
7.3
WARNING AND
INSTRUCTIONS
GRU FASSI
To Next Page
Loading...