-7-
Use a connection cable (Option) when extending the wiring distance the motor
and drive.
Prevent leakage current
Stray capacitance exists between the drive’s cable and other cables, the earth
and the motor, respectively. A high-frequency current may leak out through
such capacitance having a determental effect on the surrounding equipment.
The actual leakage current depends on the drive’s switching, the length of
wiring between the drive and motor, and so on. When connecting and earth
leaksge breaker, use the products offering resistance against high frequency
current.
Before connecting cables, check if input power is off
Otherwise, an electric shock or a fire may occur.
The case of this Ezi-SPEED is installed from the ground of the internal
circuit by the condenser. Please Ground the Ezi-SPEED.
Otherwise, an electric shock or a fire may occur and a cause of malfunction of
machine.
• Operating and setting change
If a protection function (Alarm) occurs, firstly remove its cause and then
release (Alarm reset) the protection function.
If you operate continuously without removing its cause, the machine may get
damaged or the user may get injured.
Do not change free input to ON during motor operated
Motor will be stop and holding power will be lost. The machine may get
damaged or the user may get injured.
Make all input signals to OFF before supply input voltage to Ezi-SPEED
drive.
The machine may get damaged or the user may get injured by motor
operation.
All parameter values are set by default factory setting value. Change this
value after reading this manual thoroughly.
Otherwise, the machine may get damaged or other kinds of accidents may occ
To Next Page
Loading...
Need help?
General