To Next PageTo Next Page
Need help?Do you have a question about the Felder G 360 and is the answer not in the manual?
General| Premilling unit | No |
|---|---|
| End trimming unit | Yes |
| Flush trimming unit | Yes |
| Corner rounding unit | No |
| Type | Edgebander |
| Voltage | 400 V |
| Frequency | 50 Hz |
| Weight | 440 kg |
Defines symbols used for safety instructions.
Specifies the machine's intended purpose and warns against misuse.
Defines operator duties for safe machine operation and maintenance.
Identifies electrical and mechanical hazards during operation.
Specifies qualifications and conditions for machine operators.
Details required PPE like clothing, footwear, hearing protection, gloves, and glasses.
Details mains voltage requirements and safeguarding for electrical connection.
Presents noise emission values and precautions for workplace safety.
Details the function of buttons, displays, and switches on the control panel.
Explains the operation of safety break switches and hinged lids.
Details requirements for compressed air and electrical power connections.
Explains the necessity and setup of dust extraction systems.
Specifies dust extraction port sizes and hose requirements.
Instructions for threading and setting the edge tape feeding unit.
Guidance on filling, maintaining, and settings for the glue pot.
Setting guillotine shears and pressure rollers for edge adhesion.
How to adjust the protruding edge setting for the end trimming unit.
Steps for correctly setting the pressure bar height for workpiece processing.
General safety precautions for performing maintenance and service work.
