Felder Hammer - 6. Tools and Materials Required; Setup and Operation Tools

What You Will Need to Get Going
¾Cutting knife
¾Torx head bits
¾Power drill
¾Wrenches
¾13mm, 17mm Sockets and ratchet drive
¾Screwdrivers, Flat and Crossheaded
¾Electrical provision*
¾Board, 2ft x 4ft x ½”
¾Board, 2” x 4” x 2ft
¾Pallet jack
¾An assistant (for sliding table assembly and to help bring the machine down
from it’s pallet)
*Powering Up
All new Hammer machines arrive with approximately 0,5 meters of cord and no
plug, due to the number of variations in plugs/sockets across the market.
These machines will therefore require a plug suitable for the electrical system
you already have installed.
Will Need
6.What You
¾Standard Breaker size is 30A. Please consult your electrican for details on
arranging this