Contents (2)
13. Machine Alignments
a. Saws
b. Shapers
c. Joiners
d. Planers
e. Mortisers (for combination machines)
f. All
14. Machine Adjustments / Further Info.
12. Basic Machine Checks to Make
a. How to Make 5 Sided Cut
a. SS01 Freecut from the Sliding Table
b. SS02 Centre Locked Position
c. SS03 Sliding Table End Positions
d. SS05 Crosscut Fence on Outrigger, Position A
e. SS07 Crosscut Fence Scales
f. SS08 Angled Cut From Outrigger
g. SR04+SR05 Free Cut
h. SR07 Alignment of the Saw Blade at 90
i. SR08 Alignment of the Saw Blade at 45
j. SR09 Calibration of the Rip Fence Scale
k. SH02 Shaper Spindle at 90
l. SH03 Shaper Spindle at 45
m. JR06 Joiner Test Cuts
n. JR07 Snipe Check
o. PL01 Planer Test
p. PL02 Test for Snipe
To Next Page
Loading...
