21
Reassemble 220-2 and C-220 Cutting
Assembly
To reassemble the cutting assbemlies:
1 Fit the strippers into position along the cutting
shafts.
2 Put the cutting shafts through the opening in the
left bearing plate.
3 Place the 2-piece journal bearing inset in the
opening around the cutting shafts.
4 Replace the 2 screws that hold the journal
bearing insert to the left bearing plate.
5 Slide the upper and lower distance shafts
through the stripper shrouds and strippers.
Replace the 4 screws and washers that hold
them to the left bearing plate.
6 Slide the right bearing plate over the cutting
shafts.
7 Replace the 4 screws and washers that hold the
distance shafts to the right bearing plate.
8 Place the large white gear over the large cutting
shaft gear.
9 Place the small white gear over the gray drive
gear and place the gears on the bearing plate
shaft.
10 Align the gears and replace the 6 screws and
washers that hold the gear box cover to the left
bearing plate.
To Next Page
Loading...
