Display
Mode Set here: TT450s 4800 bps or TT450s 9600bps
Frequency Set the frequency assigned to you by your country's regulatory authority.
Signal format The signal format is displayed
7.10.1.2 Configure the FENDT base station correction signal (Trimble 900 MHz)
Procedure
1.
Select the correction signal via the "Signal
Type" selection field.
NOTE:
Correction signal activation can only be
received if a green tick appears in the
connection status. Where applicable, verify
channel, frequency and signal format.
2.
Select 'Fendt Station' under station type
3.
Set the network ID
Fig. 54
Display
Satellite receiver Designation of the installed receiver
Signal type The correction signal source can be selected here
Base Type Fendt Base
Accuracy Bar indicator and decimal value of static accuracy
Signal lag Specifies the time in s taken to receive the correction signal update. If 999 is
shown here, the correction signal cannot be currently received.
Connection status Specifies the connection status of the GNSS receiver to the source of the
correction data (e.g. connected, update required, expired). The tick shows
whether the GNSS receiver is currently connected to the correction data
source.
Authorisation level Specifies the accuracy level of the GNSS receiver (depending on the hardware
modules installed in the receiver)
7. Start-up
106 VarioGuide
438.020.070.012
To Next Page
Loading...
Need help?
General