44
RECEPTION AND POSITIONING
Storage
The units must be stored in a dry place, sheltered from the sun, rain, sand and wind.
Comply with the storage conditions given below:
• Do not stack the units
• Maximum temperature = 60°C
• Minimum temperature = -10°C
• Humidity = 90%
Packing removing
Recycle and dispose of packing material in conformity with local regulations, be extremely careful not to damage the unit.
Positioning
Before positioning please consider the overall dimensions and the technical requirements of the system and the unit, electric and
hydraulic connections and any air pipes/ducts or free passages.
Neglecting these aspects may decrease performance and operational life of the unit and therefore increase the operating costs and
maintenance.
Units are designed to be installed OUTSIDE and in xed positions.
Before placing the unit be sure that:
• the location is in a safe accessible place
• the framework or the oor is adequate to support the weight of the unit WORKING (tank lled with water, etc…), please refer
to weight paragraph
• support points are leveled and aligned
• the place can not be subject to ooding
• the maximum level of the snow does not obstruct the airow to the unit
To ensure the best air circulation to the unit and thus ensure a smooth operation it is recommended to:
• avoid obstructions to air ow near or above the unit
• protect the unit from high winds that can favor or not the airow
• protect the unit from heat sources or pollutants (chimneys, extractors…)
• protect the unit from air stratication or recirculation (avoid ducting of the fans, containment structure, high walls or corners
next to the unit)
These advises if not respected can lead to a lower efciency of the unit or to high pressure stops (in summer) or low pressure stops
(in winter).
To Next Page
Loading...
Need help?
General
