Designated use
The CP modules described in this manual are desig-
nated exclusively for use in conjunction with the Festo
CP field bus node. The CP modules and CP cables
may only be used as follows:
- as intended for use
- in original condition
- without unauthorized modifications
- in faultless technical condition
If used in conjunction with commercially-available com-
ponents such as sensors and actuators, the specified
limit values for pressures, temperatures, electrical data,
torques etc. must be observed. Please comply also with
national and local safety laws and regulations.
All CP modules comply with protection class III.
WARNING
An isolating transformer as per EN 60742 (IEC 742,
DIN/VDE 0551) with at least 4 kV isolation resist-
ance is required for reliable electrical isolation of the
operating voltages.
IV CP..EA 9611A
To Next Page
Loading...
