2.3.3 Connecting the load voltage
WARNING
An isolating transformer as per EN 60742 (IEC 742,
DIN/VDE 0551) with at least 4 kV isolation resist-
ance is required for reliable electrical isolation of the
load voltages.
The connected actuators are supplied with + 24 V DC
via the load voltage connection on the output module.
Use a voltage cable with sufficient cross section for this
purpose.
Recommendation.
•• Connect the load voltage circuit via EMERGENCY
STOP.
2. Output module type CP-A08...-M12
CP-A08...-M12 9611A 2-13
To Next Page
Loading...
