1.4 Instructions on commissioning
WARNING
Please be careful if you modify the line assignment
of your CP system at a later stage.
When the line assignment has been stored, check
the address assignments of your CP system before
you start any user programs.
You thereby avoid:
– addressing errors if CP modules are incorrectly fitted.
When the line assignment has been modified (CP mo-
dules added or removed), you must store the new line
assignment by pressing the SAVE key on the node.
Proceed as described in the manual "CP system, instal-
lation and commissioning".
1. Input module type CP-E16...-M...
CP-E16...-M... 9611A 1-21
To Next Page
Loading...
