Fieldmann FZRR 5650-A - First Start; Test Parking in the Charging Base

EN 18
Installation
FZRR 5650-A, FZRR 5950-A
Two-colour LED indicator status Green Red
The power adapter and perimeter wire are properly connected to the power source Lit Not lit
The lawn mower is charging in the charging base Not lit Lit
Perimeter wire is broken or not connected to the charging base Blinks Not lit
Power adapter failure or power failure Not lit Not lit
FIRST START
Before you can use the robotic lawn mower, you must set the date and time.
1. Place the robotic lawn mower within its working area.
2. Open the control panel cover, then press the switch
.
3. Confi rm the password (see instructions in the section “Security” on page 22). After opening the control panel cover, you must confi rm the password.
4. Set the local date and time. Details on how to do this can be found in the section “Settings” on page 22.
5. Press the START button (
) and close the cover, the mower will beep for 2 seconds and then start moving.
TEST PARKING IN THE CHARGING BASE
Before using the robotic lawn mower, make sure that it can follow the perimeter wire to the charging base and that it parks easily in the charging base.
Perform the following test:
Use the steps in the section “First Start” on page 18.
1. While the robotic mower is moving within the working area, press the STOP.
2. Open the control panel cover, confi rm the password, press the HOME button (
) and then close the cover.
3. The robotic lawn mower will follow the perimeter wire clockwise to the charging base and then park into it. The test is only considered successful if the robotic
lawn mower correctly follows the perimeter wire to the charging base and parks in it on the fi rst attempt. If the robotic lawn mower fails on the fi rst attempt, it will
automatically try again. Installation is not correct if the robotic lawn mower needs two or more attempts to park in the charging base. If this is the case, check that
the charging base and the perimeter wire are installed in accordance with the instructions in sections “Installing and Connecting the Charging Base” on page 13,
“Installation of the Perimeter Wire” on page 14 and “Checking Perimeter Wire” on page 17.
IMPORTANT INFORMATION
The HOME function can only be used when the robotic lawn mower is inside the working area.