EN
ROBOTIC LAWN MOWER USER MANUAL
Usage
23
7. USAGE
CHARGING A DISCHARGED BATTERY (SEE THE "BATTERY CHARGING" SECTION)
WARNING
Before starting the robotic lawn mower, carefully read the safety instructions.
WARNING
Keep your hands and feet well away from the rotating blades. Never place hands or feet near the
mower body when the motor is running.
WARNING
Never use the robotic lawn mower when people, especially children, or pets are present in the
mowing area.
STARTING
The robotic lawn mower can be started in two ways:
Quick start by manually pressing the START button (
) and automatic start based on timer settings.
Quick Start
When the robotic lawn mower is in its working area, you can perform the quick start by pressing the START button.
1. Move the robotic lawn mower to the working zone you want to mow.
2. Open the control panel cover and switch on the mower by pressing the switch button.
3. Press the START button (
) and then close the cover.
The robotic lawn mower will start working until the battery voltage drops, then it will automatically return to the charging station.
You can also press the STOP button to stop the robotic lawnmower manually.
Cutting on the Perimeter Wire
The robotic lawn mower can also cut grass on the perimeter wire, which is skipped when mowing in the working area.
Grass cutting on the perimeter wire can only be controlled manually.
Perform the operation in the following steps:
1. Ensure that the robotic lawn mower is correctly parked in the charging base.
2. Open the control panel cover.
3. Enter the password if screen lock is activated (turned on).
4. Press the HOME button (
).
5. Close the cover.
The robotic lawn mower will leave the charging base, turn 180 degrees, and start cutting the grass above the wire.
Before the blade disc starts running, there will be 5 beeps for 2 seconds.
After the mower completes one circuit around the perimeter wire, it touches the charging base and rotates 180 degrees. It then returns along the perimeter wire back to
the charging base, but this time without cutting. Then it stops working and parks in the charging base.
IMPORTANT INFORMATION
To achieve the best cutting of grass along the perimeter wire, be sure to remove all obstacles near the perimeter wire that could
activate the collision sensor, such as branches, stones, toys, fruits, etc.
Timer Start
When setting the timer, use the following sequence:
Which day-> Which zone-> Which time
1. Open the control panel cover and press the SET button to enter the main menu.
2. The cursor is on the TIMER symbol; press the SET button to enter the sub-menu.
To Next Page
Loading...
