What to do if the shunt field current is too low on a Fincor Controller?
If the shunt field current is too low: * Check the motor shunt field and associated circuitry for a loose connection or a broken wire. Repair accordingly. * Check the motor rating, as the shunt field may be connected for incorrect voltage. * Replace BR1 or the control board, as there may be a Shunt Field Bridge BR1 failure.
Why won't my Fincor 2602 Controller motor start?
The motor may not start due to several reasons: * The AC line may be open. Ensure the rated AC line voltage is applied to the controller. * Operator controls may be inoperative or connected incorrectly; repair accordingly. * There might be an open circuit between Connectors E1 and E2 in 1/6 - 3 HP controllers. A wire jumper or switch must connect E1 to E2. * The controller may not be reset. Initiate a Stop command and then a Start command. * The controller may not be enabled; ensure +24 VDC is applied to Terminal TB2- 8. * There might be a loss of speed reference signal. Check for a 0 - 10 VDC, 4 - 20 mA, or 0 - 5 VDC speed reference signal, as applicable. * The controller may not be adjusted correctly. Turn the ACCEL and CUR LIM potentiometers fully clockwise (100%). * Th...
Essential safety guidelines for operating and servicing Fincor drive equipment.
Guidelines for controller mounting, atmosphere, construction, protection, grounding, and wiring.
Step-by-step instructions for installing the controller unit, including jumper settings.
How to energize, run, and stop the motor using the controller.
Procedures for reversing motor rotation and troubleshooting inoperative motors.
Instructions for adjusting acceleration, deceleration, speed, and current limit settings.
General| Brand | Fincor |
|---|---|
| Model | 2602 |
| Category | Controller |
| Language | English |
To Next Page