Labels
Walter Finkbeiner GmbH
Alte Poststrasse 9/11
72250 Freudenstadt / Germany
www.finkbeiner.eu
18 / 56
PB-BA-EHB702-102GB
22.02.2011
Short operation instructions
Short operation instructions – Mobile Column Lift EHB / GAB
Installation
• Locate columns on a level and sufficient load-bearing surface.
• Plug together columns by interconnect cables from column to column in a circuit around
the vehicle.
Operation
• Operation only by adult and authorised persons instructed in the handling of the lift.
• Plug-in power supply plug into prescribed mains (clockwise phase sequence!).
• Switch-on main switch, press START-button.
• Press UP respective DOWN.
Load support
• Do not exceed admissible capacity of the lift.
• Attach columns at the wheels respective pick-up points specified by vehicle manufacturer; always
two columns at one common axle.
• Check safe lifting of the vehicle immediately after load pick-up.
To regard during operation
• The operating person must not stand underneath the load during operation and has to observe
sufficient safety clearance towards the moving parts of the lift.
• The operating person has to pay attention that the movement area of the lift is free from any
obstacles and that no persons stay therein.
• The operating person has to supervise constantly the lift and the lifted load and has to stop
operation immediately if anything is working not correctly.
• Do not ride on the lifted vehicle or on the load attachments.
• Do not climb up the lift or the lifted vehicle.
• After operation the main switch has to be switched-off and locked against unauthorised use.
• Regard Operation Manual of the lift.
To Next Page
Loading...