Commissioning
Walter Finkbeiner GmbH
Alte Poststrasse 9/11
72250 Freudenstadt / Germany
www.finkbeiner.eu
20 / 56
PB-BA-EHB702-102GB
22.02.2011
5.4 Electrical connection
• If lift has been delivered without power supply plug (country-specific) mount appropriate plug to
power supply cable.
WARNING
Hazard of material damage by wrong operation voltage.
• Take care that lift is connected to the prescribed power supply (see manufac-
turer nameplate).
• Connect power supply plug into appropriate mains.
• Clockwise phase sequence required. Turning direction if incorrect can be changed as follows:
Unplug lift from mains, open plug and change phase connections L1 and L2. Close plug correctly
again.
• If the lift is used at some other location or at use of an electrical extension cable the phase se-
quence may be incorrect and needs to be checked again.
To Next Page
Loading...