Fire-Lite MS-9200UD - 3.6.2 Point Program; 3.6.2.1 Detector Programming; 3.6.2.1.1 Add Detector

3URJUDPPLQJ 0DVWHU3URJUDPPLQJ/HYHO
 068'31$
3.6.2 Point Program
The Point Program option allows the programmer to add a new addressable device to an
SLC loop, delete an existing device from a loop or change the programming for an
existing device. Pressing 2, while viewing Programming Screen #1, will select the
Point Program option and display the following screen:
3.6.2.1 Detector Programming
3UHVVLQJ

ZKLOHYLHZLQJWKH3RLQW3URJUDP6FUHHQZLOODOORZWKHSURJUDPPHUWR
DGGGHOHWHRUFKDQJHWKHSURJUDPPLQJRIDQDGGUHVVDEOHGHWHFWRU7KHIROORZLQJ
VFUHHQZLOOEHGLVSOD\HGE\WKHFRQWUROSDQHO
3.6.2.1.1 Add Detector
3UHVVLQJ

ZKLOHYLHZLQJWKH'HWHFWRU6FUHHQZLOOGLVSOD\WKHIROORZLQJVFUHHQ
ZKLFKDOORZVWKHSURJUDPPHUWRDGGDQHZGHWHFWRUDGGUHVVWRSURJUDPPLQJ
$IODVKLQJFXUVRUZLOODSSHDULQWKHSRVLWLRQRIWKHILUVWDVWHULVNWRWKHOHIW7KH
SURJUDPPHUNH\VLQWKHWKUHHGLJLWGHWHFWRUDGGUHVVVXFKDV
:KHQWKHODVWGLJLWLVNH\HGLQWKHIROORZLQJVFUHHQZLOOEHGLVSOD\HG
7KHSURJUDPPHUFDQFRQWLQXHDGGLQJGHWHFWRUVE\SUHVVLQJWKH
(6&
NH\ZKLFKZLOO
UHWXUQWKHGLVSOD\WRWKH$GG'HWHFWRU6FUHHQ
PROGRAMMING
1=AUTOPROGRAM
2=POINT PROGRAM
3=ZONE SETUP
Programming Screen #1
POINT PROGRAM
SELECT TYPE
1=DETECTOR
2=MODULE
Point Program Screen
DETECTOR
1=ADD
2=DELETE
3=EDIT
Detector Screen


ADD DETECTOR
ENTER DETECTOR#
***
Add Detector Screen
ADD DETECTOR
DETECTOR# 005
IS ADDED