This Control panel can be programmed using the respective Software J400 release 1.1 or higher.
BENTEL SECURITYsrl shall not assume the responsibility for damage arising from improper application or use.
This Control panel has been designed and manufactured to the highest standards of quality and performance.
Installation of this Control panel must be carried out strictly in accordance with the instructions described in this manual, and
in compliance with the local laws and bylaws in force
The J424 and J408 Control panels comply with the essential requirements of standards EN54-2; EN54-4; EN12094-1.
EN12094-1 certification shall be deemed void if the J400-EXT Extinguishment Module is not installed in the Control panel.
The manufacturer reserves the right to change the technical specifications of these products without prior notice.
Recycling information
The manufacturer recommends that customers dispose of their used
equipments (panels, detectors, sirens, and other devices) in an envi
-
ronmentally sound manner. Potential methods include reuse of parts
or whole products and recycling of products, components, and/or ma
-
terials.
Waste Electrical and Electronic Equipment (WEEE) Di
-
rective
In the European Union, this label indicates that this product sho
-
uld NOT be disposed of with household waste. It should be deposited
at an appropriate facility to enable recovery and recycling.
EN12094-1
Electrical automatic control and delay device
Environmental class A
Protection level IP30
Flooding zones 1 to 4
CO2, inert gas, halogenate hydrocarbon
Expected Options:
– Delay of extinguishing signal
Response delay activated condition: maximum 3 s
– Monitoring of status of components
– Emergency hold device
– Control of flooding time
Response delay triggering of outputs: maximum 1 s
0051-CPD-0197 (J400-EXT in J424)
(J400-EXT in J408-2/J408-4/J408-8)
0051-CPD-0196
09
0051
BENTEL SECURITY s.r.l.
Via Gabbiano, 22 - Zona Ind. S. Scolastica
64013 Corropoli (TE) - ITALY
0051
0051 - CPD - 0192
0051 - CPD - 0193
0051 - CPD - 0194
0051 - CPD - 0195
EN 54-2 1997+A1 2006::
Control and indicating equipment for fire detection and fire alarm
systems for buildings.
09
(J408-2)
(J408-4)
(J408-8)
(J424)
BENTEL SECURITY s.r.l.
Via Gabbiano, 22 - Zona Ind. S. Scolastica
64013 Corropoli (TE) - ITALY
EXPECTED
:typeC
OPTIONS
Dependencies on more than one alarm signal
Delays to outputs
Test condition
Output to fire alarm devices
Output to fire alarm routing equipment
To Next Page
Loading...
