Need help?Do you have a question about the FireClass Prescient III and is the answer not in the manual?
General| Brand | FireClass |
|---|---|
| Model | Prescient III |
| Category | Smoke Alarm |
| Language | English |
Details the three monitored detection zone circuits for fire detection and alarm.
Describes the manual release inputs and panel-mounted call point functionality.
Explains the two monitored output circuits for activating the extinguishing system.
Details the relay contact for first stage system shutdown.
Details the relay contact for second stage system shutdown.
Details the relay contact for third stage system shutdown.
Describes the relay contact for gas discharged signal.
Details the DIL switches for configuring various panel functions.
Configures the pre-discharge delay timer duration in 5-second increments.
Bypasses the pre-discharge delay timer for immediate manual release.
Yellow LED pulses for any general fault on the panel.
Yellow LED pulses for mains or battery failure.
Lists available operating modes for configurable circuits.
Procedure for disabling, re-enabling, and testing panel circuits.
Describes panel response to fire in two extinguishing zones.
Details the panel's reaction when manual release is activated.
Describes the panel's state and actions when the extinguishing system is activated.
Explains the effect of emergency hold on the pre-discharge timer.
Details how emergency abort stops the extinguishant release.
Guideline for calculating required battery capacity based on load and time.
Information on the lifespan and scheduled replacement of standby batteries.
Details the battery charger voltage and adjustment for optimal charging.
Crucial safety warnings related to handling and connecting batteries.
Highlights electrical safety requirements and precautions during installation.
Describes the procedure for weekly testing of call points, detectors, and switches.
Information on battery lifespan, testing, and replacement intervals.
Shows wiring for detection zones, manual call points, and release switches.
Illustrates wiring for sounder circuits and actuator solenoids.
Diagrams for connecting monitored inputs like gas pressure and isolation valves.
Shows wiring for monitored output signals such as stage shutdowns and fault signals.
Illustrates connections for remote outputs and Status Lamp Unit communication.
To Next Page
