AUTO: Select Automatic mode (AUTO) from the command and display interface to enter that mode.
The following information is shown on the Display through 2 screens that alternate continuously.
Screen 1:
❖ Name of the Company: FISAIR, S.L.U.
❖ Status indication: HEF2E→ ON (AUTO)
Screen 2:
❖ Date: 01/01/2019
❖ Time: 21:00
❖ Conductivity value and water temperature
(µS/cm). * In the case of having conductivity
Control.
*** If there is a fault, an alarm code is shown on the second line of the display; see section 10
“Alarms” for more information
To Next Page
Loading...