5. Operation:
I. If the UV lamp is on, the LED flashes blue until the confirmation of the ignition
sensor is received. It will then stop flashing and be lit continuously in blue. If the lamp
is submerged, J18 must be bridged (IN1) as it works for hours.
II. Once the working mode has been chosen (MAN or AUTO), the water supply solenoid
valve LED lights up to fill the basin until the mechanical float valve closes. If
there is a fault in the mechanical float valve, the basin continues filling until the level
sensor detects the maximum water level (LED turns red)
III. Once the minimum water level has been reached (green LED ), the water
recirculation pump turns on (green LED ) after the time established in TIMER
TO1
IV. During operation or after switching off, the LEDs will light up depending on
the emptying settings.
V. During the operation - whether MAN or AUT - an alarm code will be seen on the
display if there is an anomaly. (see section 5 “supervision”)
VI. If the equipment has a conductivity meter option:
The conductivity reading will appear in the display in μS/cm. (see section 5
“supervision”)
To Next Page
Loading...