9
Getting started quickly
Using your washer
The buttons require only a gentle touch to activate.
1
Touch POWER to activate your CleanSmart™ washer.
2
Select your desired wash cycle by turning the SmartTouch Control Dial. The wash cycle icons will
illuminate as you turn the dial, showing which cycle is selected (refer to pages 18 – 22 for detail
about the wash cycles).
3
High Efficiency - this allows you to select either a high efficiency (High Efficiency On – to save
water) or conventional cycle (High Efficiency Off – to use more water when needed) (refer to
page 12).
4
Choose your wash options. For example, if you would like a warm wash temperature, touch the
WASH TEMP button until the light next to ‘Warm’ is lit. If you wish to use fabric softener, ensure
SOFTENER is selected in OPTIONS (refer to pages 23 and 24).
5
Touch START / PAUSE to start the cycle and let CleanSmart™ do the rest for you. The washer will
start to fill with water and will automatically select the correct water level and wash action for
your load.
Please note: constant interruptions to the cycle, such as touching START / PAUSE will increase the
time taken to complete the cycle and may result in poorer washperformance.
6
Use KEYLOCK to lock the buttons on the control panel, preventing them from being activated
accidently (refer to page 10).
7
DELAY START allows you to delay the start of your wash by 5 mins up to 18 hours (refer to page 24).
For best fabric and colour care, remove your clothes as soon as the cycle has finished.
Important!
Failure to follow the advice in this guide may result in damage to your garments and your
expectations of wash performance may not be met.
53 47
To Next Page
Loading...
Need help?
General
