Fisher & Paykel CleanSmart - Before You Do Your First Wash; Machine Information

7
Before you start, it is a good idea to go through the following checklist:
1
Has the base packer been removed?
2
Is the drain hose threaded through the ‘U bend’ hose guide
(with no more than 20 mm extended) and hooked into your standpipe?
3
Is the hot hose connected to the Hot valve marked ‘H’?
Is the cold hose connected to the Cold valve marked ‘C’?
4
Is the machine correctly levelled, feet extended and cabinet corners clear
of the floor? Refer to page 5.
5
Have you performed the installation test cycle? Refer to page 6.
CleanSmart™ capacity
CleanSmart™ offers a very generous 10 kg capacity. The list below outlines what is included in a
10kg wash load (in accordance with AS / NZS 2040.1:2005).
10 kg load
4 Sheets (double) 6 Pillowcases
8 Bath towels 6 Shorts
3 Tablecloths 4 Wash cloths
4 Shirts 2 Handkerchiefs
6 T-shirts
Note: the above load compositions are indicative only. We recommend for everyday use that you
separate out your sheets and towels and wash them on the cycles specifically designed for them.
The REGULAR cycle, with High Efficiency ON and ECO option selected, is the recommended
water and energy saving cycle for normally soiled, everyday washing.
Machine information
Specifications
Model Capacity Depth Width Height* Height (lid open)
WL1068P 10.0 kg 700mm 685mm 1060 – 1090mm 1440 – 1470mm
* Height is measured to the highest point on the console.
Electrical supply: 220 – 240 V, 50 Hz Sinusoidal, 10 A
Inlet water static pressure: Max. 1 MPa (150 psi), Min. 34 kPa (5 psi)
Inlet water flow rate at tap: Min. 6 litres / min
Standpipe height: 850 – 2400mm
Note: the exact height of your washer is dependent on how far the feet are extended from the
base of the machine.
Before you do your rst wash