24
Wash cycle options
Spin Speed
Your CleanSmart™ washer offers three spin speeds: FAST (1100 rpm), MEDIUM (670 rpm) and
SLOW (330 rpm), plus an additional SPIN HOLD option. Simply increase or decrease your spin
speed by touching the SPIN SPEED button. SPIN HOLD will pause the washer at the end of the
rinse, allowing you to remove drip-dry items before you proceed the washer to its final spin
(touch START / PAUSE to start the spin).
Wash Boost
If you have stains in your wash load that you need to treat or wish to perform a double wash,
select STAIN TREATMENT or DUAL WASH from the WASH BOOST options. Refer to page17 for
detailed information on these options.
Options
Soak
The SOAK option provides a two hour soak during the middle of the wash phase of the cycle.
The machine will then complete the rest of the cycle. During SOAK, the washer will agitate for
a few seconds every minute. To perform a soak during a cycle, simply select SOAK from the
OPTIONS menu.
To exit SOAK, touch START / PAUSE and turn the dial to select RINSE. Change the SPIN SPEED if
necessary (eg select SLOW if washing handwash only, delicate, or creasable items) and touch
START / PAUSE.
Note: if the soak option is selected on a QUICK cycle, the soak time will be one hour only.
Important!
Ensure items are colourfast before using soak.
Eco
Use the ECO option to save water. The ECO option uses a spray rinse which has been specially
designed to use at least 25% less water than a traditional rinse. Use this option when you want to
use less detergent and less water. However, if you have low water pressure or sensitive skin it is
better to use a traditional rinse.
Note: the ECO option is available on selected cycles only. If ECO is not available for a cycle, your
washer will skip over it in the OPTIONS menu.
Softener
If you wish to use fabric softener, ensure SOFTENER is selected. This will adjust the rinse part of
the cycle so that softener is dispensed correctly (refer to page 16).
Delay Start
The DELAY START option can delay the start of the wash cycle between 5 minutes and 18hours.
This can be useful to time your washing to finish when you arrive home from work, or to start
once you have finished in the shower. Simply touch the MORE
button to increase the delay
time, and LESS
button to decrease the time, or turn DELAY START off. Touch START / PAUSE to
confirm your selection and start the countdown.
Note: we suggest that you avoid using DELAY START for damp, non-colourfast items as this may
cause dye run to occur.
To Next Page
Loading...
Need help?
General
