Fisher & Paykel CleanSmart - Caring for Your Washer

31
Caring for your washer
When you have finished using your washer
Turn off the taps to prevent the chance of flooding should a
hose burst.
Unplug the machine from the power socket.
Cleaning your CleanSmart™
Before you start cleaning your CleanSmart™ washer, ensure
that it is disconnected from the power (ie unplug the
machine from the power socket).
Cleaning the control panel, topdeck and lid
Use a soft damp cloth to wipe all surfaces, and wipe dry.
Avoid using chemical or scouring cleaners, as these will
damage the paint and plastic surfaces of your washer.
Important!
The SmartTouch Control Dial and soft close lid are not
designed to be removable for cleaning. Do not attempt to
remove the dial or lid.
Cleaning the detergent, fabric softener, and
Wash Boost dispensers
Wipe out the detergent dispenser with a damp cloth. The
funnels (tops) of both the fabric softener and Wash Boost
dispensers click off easily. Simply place a finger down the
centre and lift. The fabric softener and Wash Boost dispenser
compartments are not removable and need to be wiped
clean periodically. If the siphon tube on either dispenser
looks partially blocked use a cotton bud to clean.
Cleaning the inside of your washer
It is important that you occasionally clean the inside of your machine. Your CleanSmart™ has
a BOWL CLEAN cycle specifically for this purpose and will remind you every 100 cycles to run
this cycle (the BOWL CLEAN cycle icon will flash to alert you), or we recommend completing
this cycle 5–6 times a year. We suggest that you do not have any items in the washer when
you run this cycle.
Cleaning steps
1
Add approximately 2 full scoops of a good quality powdered detergent directly into the
detergent dispenser.
2
Touch POWER to turn your machine on and select the BOWL CLEAN cycle.
3
Touch START / PAUSE to start the cycle (refer to page 21 for cycle details).
Fig.26 Removing the
Wash Boost funnel
Fig.25 Removing the
fabricsoftener funnel