32
Cleaning your low-profile agitator
If your low-profile agitator becomes stained we recommend you use household bleach to clean
it. Ensure you wear gloves. Tip a small amount of household bleach onto a soft cloth and apply
to the stain. Be careful to avoid metal surfaces of your machine. Leave it to soak in for 10 minutes
and repeat. Then put your CleanSmart™ washer through the BOWL CLEAN cycle to remove any
residual bleach (refer to page 31).
Automatic lint disposal system
With CleanSmart™ there is no need to remove messy lint filters. Your CleanSmart™ has a self
cleaning lint disposal system. It automatically separates the lint from the wash water as it
washes. The lint becomes trapped between the inner and outer bowls and is flushed out at the
end of the wash.
Nappy sanitisers / bleach
Nappy sanitisers and bleach are very corrosive to metal surfaces. DO NOT use your CleanSmart™
to soak items in bleach or sanitiser, or tip the contents of a nappy bucket into your machine.
Rinse and wring items out thoroughly before placing them in the machine.
Caring for your washer
To Next Page
Loading...
Need help?
General
