34
Before you call for service
“Sud LOC” (suds lock – I have too many suds)
Your machine has a suds build-up. Too much detergent may have been used for the amount of
soil in the load.
Ensure that you are using a HE, Low Sudsing, Matic or Front Loader type detergent.
Wait for suds to dissolve (about 20 minutes).
Restart the cycle from the start (do not add more detergent).
Check the standpipe height does not exceed 2400 mm.
If using the DUAL WASH option, reduce the amount of detergent placed in the detergent
dispenser.
“Lid LOC” or “Lid OPn” (lid lock or lid open – I can’t lock the lid or the lid is open)
Check that the lid is closed.
Press START / PAUSE (refer to page 11).
If the symptom persists, call your Fisher & Paykel Authorised Repairer.
“too FUL” (too full – I am overloaded)
Your machine is overloaded and cannot continue the cycle.
Ensure the machine is stationary and remove items until the remaining ones can move freely.
Check that the machine is not siphoning (refer to page 3).
Single beep every second and...
A number shows on the display (this is a fault code)
1
Turn your machine off at the wall.
2
Wait 1 minute and turn it back on.
3
Check your machine is level (refer to page 5).
4
Remove load and retry.
5
Perform a RINSE cycle (refer to page 22).
6
If the fault re-occurs repeat steps 1 and 2.
If the machine still will not work, call your Fisher & Paykel Authorised Repairer to arrange service
(refer to page 41).
To Next Page
Loading...
Need help?
General
