l-l
1
1.1
1.2
1.3 Controller Description
May 1997
UM6.1:DPFt900’9102
Introduction
Scope
This manual provides information required for installation, operation,
and configuration of the DPRSOO Integral Controller.
Description of Manual
Section 1 = Introduces the user to the organization of the manual,
contents of other sections, and DPRSOO Controller specifications.
Section 2 = Describes the mechanical and electrical installation
procedures for the controller, including power and grounding
requirements.
Section 3 = Explains the functions and use of the front panel controls
and indicators.
Section 4 = A brief description of the procedures used to set
FCODE’s.
Section 5 = Instructions for configuring the DPRSOO Controller.
Appendix A = Fault Codes
Appendix B = FCODE Index
Appendix C = Field Replaceable Pans
The DPRSOO Integral Controller is a single-loop, proportional, integral,
derivative (PID), user-configurable controller. All controller functions
reside in the controller. Configuration consists of selecting the
appropriate functions and setting the tuning parameters, using the
controls and indicators on the front panel. Configuration may be
entered or changed while the controller is operating. The controller
scans and updates all input and output signals five times a second.
When the controller is communicating with a computer via the RS-485
serial interface, this I/O scan and update rate is not valid, due to
communications link limitations. Connection to and communication
with external equipment is via four analog and four digital inputs, two
analog and six digital outputs, and a serial data port (RS-485).
To Next Page
Loading...
