2
2.1
Installation
Mechanical Installation
The DPRSOO Integral Controller units fit into a cutout in a vertical
panel, allowing for high packing density. The cutout may be for a
single controller unit or for multiple units mounted side by side. For
typical installations the panel must be between 0.06 inch (2 mm) and
0.16 inch (4 mm) thick. For installation information on thicker panels,
contact your Fisher Representative.
The figure shows a controller’s external dimensions, along with the
spacing and dimensions for panel cutouts. Front panel cutouts
conform to DIN standards.
4b
Caution
The panel must be able to support the
weight of all controllers mounted in it. A
large number of controllers in a panel may
require additional panel support.
ic
I I I
DPRSOO Mounting Cassette Dimensions
May 1991
lJM6.1:DPR900:9102
To Next Page
Loading...
