FiT REMOTE DISPLAY - Page 37

INSTRUCTION MANUAL FIT REMOTE DISPLAY PINION
Error code Error message displayed Action / Restriction
0F-0A Charger update error 1. Restart the system.
2. Switch the system off.
3. Disconnect the charger from the system and
socket.
4. Wait until status LED goes out.
5. Check plug contacts on the e-bike and charger
and clean if necessary.
6. Reconnect the charger to the socket.
7. Reconnect the charger to the system and start
the system.
8. If the problem persists, please contact your
specialist dealer.
0F-0B Lock update error 1. Restart the system.
2. If the problem persists, please contact your
specialist dealer.
10-xx Remote software error 1. Restart the system.
2. If the problem persists, please contact your
specialist dealer.
11-xx Battery remote communication
error
1. Restart the system.
2. If the problem persists, please contact your
specialist dealer.
12-01 Remote motor pairing error 1. Restart the system.
2. If the problem persists, please contact your
specialist dealer.
12-02 Remote display pairing error 1. Restart the system.
2. Switch the system off.
3. Remove display from holder, check contacts and
clean if necessary.
4. Re-insert the display and start the system.
5. If the problem persists, please contact your
specialist dealer.
12-03, 12-04,
12-05, 12-06
Remote battery pairing error 1. Restart the system.
2. Switch the system off.
3. Remove the battery from the holder, check
contacts and clean if necessary.
4. Re-insert the battery and start the system.
5. If the problem persists, please contact your
specialist dealer.
12-07 Remote speed node pairing error 1. Restart the system.
2. If the problem persists, please contact your
specialist dealer.
12-08 Remote gears pairing error 1. Restart the system.
2. If the problem persists, please contact your
specialist dealer.
FIT_Manual_Remote_Display_Pinion_V3_en | Version 03 | 24.10.2023 37