Dreamer NX User Guide | www.flashforge.com
and USB cable in the shipping box. In the Tool Bag, you can find a
Stamping Wrench, a Carving Knife, a Scraper, Tweezer, Grease, Allen
Wrenches, Screwdriver, a SD card, a Leveling Nut, PTFE Tube.
3-3
4.（3-4）You can find an accessory box on top of Dreamer NX, which houses
the extruder set. Remove the box and the foam sheet from the Dreamer NX,
and gently lay the extruder set on the Dreamer NX build plate.
Inside the accessory box, you will find an extruder, a turbofan baffle, and
two pieces of removable side panels.
3-4
5. (3-5) Elevate the build plate up carefully.
To Next Page
Loading...
