Dreamer NX User Guide | www.flashforge.com
Click the [View] icon and then you can move the object by the following three
Method 1: Hold down the left mouse button and drag.
Method 2: Hold down the mouse wheel and scroll up and down.
Method 3: Hold down the Shift key, hold down the right mouse button and
Click the [View] icon and then you can rotate the object by the following two
Method 1. Hold down the right mouse button and drag.
Method 2. Hold down the Shift key, hold down the left mouse button and drag.
Rotate the mouse wheel to enlarge or shrink the build plate.
② Set View
Allow users to view the object on the build plate. Six views are under the view
menu, that is, bottom view, top view, front view, back view, left view and right
Method 1: Click the the [View] button, there are six views in the drop- down
Method 2: Click the the [Look] icon on the left, click it again and a submenu
will appear with six views for selecting.
Allow users to reset views by the following two methods:
Method 1: Click the [View] menu and select [Home View]
Method 2: Click the [View] button on the left, click it again and you will see the
viewing options, you can click [Reset].
To Next Page
Loading...
