Q19. How to connect to Polar Cloud?
Pictures can save up to 10 models, while videos can save 20 models.
The printer adopts fast-slow loading. Please makes sure there is no remaining
filament in the guide tube.
Q23. Noise in the gear when loading filaments?
Q20. How to connect to FlashCloud?
Q21. How to use the camera?
In the expert mode, the distance can be adjusted directly for experienced users.
Details can be found in the calibration instructions for the expert mode.
Q24. What is the expert mode in calibration?
Q25. How to set printing parameters during printing?
Pay attention to the distance when it moves along the side to avoid
hitting the border.
Q22
. Operation of movement
When the length is not selected, press the button to start the movement, and
release the button to stop the movement;
When the length is selected, press to start the movement, release will not stop the
movement until the corresponding length is reached.
1.
2.
Note
Note
29
1. Open the Polar Cloud website and log in your account. Website: https://polar3d.com;
2. Click the icon on the top right corner and roll down the page to find the PIN code;
3. Open the Polar Cloud interface on the printer, and enter the account number and PIN code;
4. Turn on the Polar Cloud switch to connect to Polar Cloud.
1. Open the FlashCloud website: https://cloud.sz3dp.com/login.html;
2. Open the FlashCloud interface or About interface on the printer;
3. Add the printer on the FlashCloud website, and enter the name and registration code
of the printer;
4. Turn on the FlashCloud switch to connect to FlashCloud.
1. Enable the camera function to view the live video on the cloud;
2. The time-lapse function will capture and save 100 pictures during printing, and
compress them into a video after printing.
Enter the print details interface to adjust the parameters. Note that adjustments might be
delayed to take effect, or improper adjustments will affect the printing quality. Please set
it carefully.
To Next Page
Loading...
