Flashforge Creator Pro - Leveling Build Plate

FF Creator Pro
Print from SD
Preheat
Utilities
PlateLeveling.x3g
type
1
Exit Menu
(2)
_
ENG
Exit Menu
Leveling Build Plate
(1) Attach the power supply, plug the power cord into an electrical outlet
and turn on the printer.
(2) Insert the SD card into the slot. Select [Print from SD] and press [OK].
Select [ENG] and press [OK].
Then you will see the [Plateleveling.x3g].
Raise the build plate to reduce the distance
between the nozzle and build plate.
Lower the build plate to increase the distance
between the nozzle and build plate.
SD Card Input
(1)
Turn the knob clockwise Turn the knob anticlockwise
Adjust the leveling knobs to level the build plate