Flashforge DREAMER - Introduction

04
7. Remove the bubble wrap from extruder and
slide the X-axis rods to the middle of printer
(A extruder seat on the X-axis).
8. Place the dual extruder on the extruder seat,
as shown.
10. Elevate the build plate to its limit. Notes:
Do not let build plate touch the extruder.
11. Remove both filament rolls and foam pieces
from printer.
Note: Take both spool holders out of the foam.
9. Remove the foam from the back of the logo
board.
12. Lower the build plate fully. Congratulations!
You've unpacked your printer. (Tip: Save
packaging for future transportation and
storage)