FlashPoint XPLOR 600 Pro R2 - Protection Function; Over-Temperature Protection; Error Messages

22
Number of Flashes
75
100
120
150
200
300
1000
Power Output Level
1/1
1/2 (+0.3,+0.7)
1/2 (+0.3)
1/2
1/4 (+0.3,+0.7)
1/8 (+0.3,+0.7)
400
500
1/16 (+0.3,+0.7)
1/32 (+0.3,+0.7)
1/64 (+0.3,+0.7)
1/128 (+0.3,+0.7)
1/256 (+0.3,+0.7)
Times
50
60
75
100
150
200
Power Output
1/1
1/2 (+0.3,+0.7)
1/4 (+0.3,+0.7)
1/8 (+0.3,+0.7)
300
1/16 (+0.3,+0.7)
1/32 (+0.3,+0.7)
1/64 (+0.3,+0.7)
1/128 (+0.3,+0.7)
1/256 (+0.3,+0.7)
Protection Function
1. Over-Temperature Protection
Error Messages
Number of flashes that will activate over-temperature protection:
• To avoid overheating and deteriorating the flash head, do not fire more than 75 continuous
flashes in fast succession at 1/1 full power. After 75 continuous flashes, allow a rest time of at
least 5 minutes.
• If you fire more than 75 continuous flashes and then fire more flashes in short intervals, the
inner overtemperature protection function may be activated and make the recycling time
over 10 seconds. If this occurs, allow a rest time of about 5 minutes, and the flash unit will
then return to normal.
• When the over-temperature protection is started, is shown on the LCD display.
• The system provides real-time protection to secure the device and your safety.
The following lists prompts for your reference:
Number of flashes that will activate over-temperature protection
in HSS high-speed sync triggering mode:
MeaningLCD Panel
Error 1
A failure occurs on the recycling system so that the ash cannot re.Please restart the
ash unit. If the problem still exists, please send this product to a maintenance center.
Error 3
The voltage output of the ash tube is too high.
Please send this product to a maintenance center.
Error 9
There are some errors occurred during the upgrading process.
Please using the correct rmware upgrade method.