Safety Instructions
• Always keep this product dry. Do not use in rain or in damp conditions.
• This product contains high-voltage electronic parts. Touching the high-voltage
circuit inside it may result in electric shock. Do not disassemble. Should repairs
become necessary, this product must be sent to an authorized maintenance
center.
• Stop using this product if it breaks open due to impact or force. Electric shock
may occur if you touch the internal parts.
• Do not use the ash unit in the presence of ammable gases, chemicals and
ignitable materials. In certain circumstances, these materials may be sensitive
to the strong light or electromagnetic interference emitted from this ash unit.
• Do not leave or store the ash unit if the ambient temperature reaches over
120°F/50°C (e.g. in a sun bathed automobile). Electronic parts may be
permanently damaged.
• Do not use any power supply to charge the battery, other than the one
included.
• Do not insert metal parts into any lighting equipment.
• Do not touch the electrical contacts on the strobe or battery or contact them
with any conductive materials.
• Do not re the ash directly into the eyes, especially those of babies, within
short distances. Visual impairment may occur. When taking pictures of babies,
keep the ash unit at least 3.3 feet (1 meter) away from them. Using bounce
ash to reduce light intensity is also recommended.
• This strobe has an over-heat protection circuit, rapid continuous ring will
cause the strobe to slow operation and trigger a “cool down” period. After this
period, the strobe will resume normal operation. You may also reset the strobe
by cycling the power o and then on again.
• The strobe has a locking mechanism to ensure secure operation. To avoid
damage, slide the release before removing any reectors or accessories.
• In case of abnormal function, sparks, excessive heat, ames or smoke,
immediately power o the unit and disconnect the battery, if safely possible.
Have it checked by an authorized technician.
02
To Next Page
Loading...
