Heritage
Information
ELECTRICAL CIRCUIT BREAKER PANELS, CIRCUIT FUSE PANELS AND
BATTERY
DISCONNECT SWITCH LOCATIONS
American Heritage
• Chassis 12-Volt Fuse Front Panel ................................. In the entry step-well
• Chassis Fuse 12-Volt Fuse Rear Panel.. ........................
In
the battery compartment
• Chassis 12-Volt Battery Disconnect Switch .................. Rear engine access compartment
• House 12-Volt Battery Disconnect Switch ....................
By
the entry door
• House 12-Volt Fuse Panel .............................................
In
the basement
in
front
of
the batteries
• House 120-Volt Breaker Panel ...................................... Under the bed top
A CAUTION A WARNING
Before relamping, disconnect power source by remov-
ing fuse or
placing circuit breaker and control switch in
OFF position.
Do not
install 12-volt fuses or 120-volt breakers with
amperage ratings greater than that specified on the
device or
label. Doing so constitutes a fire hazard.
Halogen bulbs operate at extremely high temperatures
and pressures and will shatter if not
handled correctly.
Always
use a soft dry cloth or cotton gloves when han-
dling halogen bulbs.
Do not touch glass area with bare hands.
If
bulb is
touched with bare hands, wipe the
bulb clean with rub-
bing
alcohol.
Do not use near flammable or combustible materials
and/or objects which may be sensitive to fading or drying.
Use
bulbs designed or specific by manufacturer as
to
style, wattage and voltage.
04-5
To Next Page
Loading...
