Plumbing
Systems
and
Holding
Tanks
A CAUTION
Overfilling the
fresh
water tank
from
a pressurized
source may cause damage
to
the water system.
Monitor water tank
filling continually.
2.
Gravity
fill-The
external gravity water fill
is located on the exterior
of
the motor
home. The on-board water tank can be
filled here.
To
fill the fresh water tank,
remove the cap, remove the vent plug, and
fill the tank using a potable water hose.
Typical Gravity Fresh Water Tank Fill
Draining the Fresh Water Tank
Avoid leaving the water in the tank when the
motor home is not
in
use. Turn the water pump
OFF before draining the water tank. Whenever
possible, drain the fresh water tank before trav-
eling. Water in the tank will reduce the carrying
capacity
of
the motor home. See Motor Home
Loadillg
section
of
the
011
The
Road
chapter.
The main water tank
"quick-drain" valve may
be located on the end
of
the water tank, or in the
utility compartment.
Water Pump
The on-board fresh water system is pressurized
by a self-priming, 12-volt
DC
pump. The pump
operates automatically when the pump power
switch is
ON and a faucet is opened. When the
faucets are closed, the pump shuts off.
It
can
lUn
dry for extended periods without damage. See
Electrical Systems chapter.
07-2
Turn the pump master switch ON to pressurize
the system. When a faucet is opened after the
initial filling
of
the tank, the water may sputter
for a few seconds. This is normal and is not
cause for concern. The water flow will become
steady when all air is bled from the water lines.
,/1
NOTE 1
Turn
water pump off before traveling. Road vibration
could cause a faucet to open.
If
the water pump
is
on,
your fresh water supply could be pumped into the
holding tank.
Water Pump Filter
Dill, mineral scale, and organic matter are filtered
out
of
the fresh water system by an in-line water
filter on the inlet side
of
the water pump.
If
you
suspect a clogged filter, it is easily removed and
cleaned.
Inspect the filter after running the first full tank
of
water. Clean and inspect monthly thereafter.
The filter is located in the utility compartment
behind the service panel.
l.
Loosen the clamp at the inlet end
of
the
filter.
2. Pull the water line off the filter.
3.
Unscrew the filter from the water pump.
4. Thrn each end
of
the filter and pull apart.
5. Flush out and clean screen.
6.
Reverse procedure to install.
7.
Operate the water pump and check for leaks.
Low
Point Drains
To
drain
hot
and
cold lines:
l.
Open hot and cold low point drains.
2.
Open the shower handle and faucet until all
water has drained from the lines.
Troubleshooting the
Fresh Water
System
Water system problems usually fall into two
categories: Inherent system problems, and prob-
lems caused by neglect. System problems are
To Next Page
Loading...
