The adhesives and sealants used in the construc-
tion
of
your motor home were developed to
remain waterproof under sustained effects
of
weather and vibration. However, even the finest
materials will eventually dry out and lose their
effectiveness.
.1'1
NOTE 1
Failure
to
seal could cause serious damage
and
will
affect your warranty coverage.
Your dealer can perform the resealing inspection
and work for you. Your dealer also has current
information on sealants used in your motor
home, and can recommend the appropriate
sealants for you
if
you prefer to do this work
yourself. Always use the recommended sealants.
DOOR, WINDOW, ROOF
COMPONENT
AND MOLDING
RESEALING
Inspect the sealants around windows, floors,
joints and doors at least every three months.
Also inspect roof vents, other roof components,
moldings at front and rear caps, and perimeter
molding.
If
any
of
the following defects are
evident during inspection, the affected areas
must be resealed.
• Sealant cracked or peeling.
• Void or missing sealant.
If
you find any
ofthe
above defects:
1.
Clean all areas to
be
resealed with an
appropriate cleaner and clean rags.
2.
Make sure that all areas to be resealed are
absolutely dry before new sealant is applied.
.1'1
NOTE 1
Do
not
seal the bottom flanges
of
windows
and
doors.
Special gaps in the sealant have been intentionally
left in the bottom flange
to
provide drainage.
Maintenance
INTERIOR
Fabrics
Interior appointments such as draperies, bed-
spreads, mattress covers, upholstery and wall
pads are manufactured from high quality materi-
als and should
be
dry cleaned only. Frequent
vacuuming will keep them free
of
dust and dirt.
Minor spills should be cleaned up quickly to
avoid staining. The affected area should be
blot-
ted, not rubbed, to prevent the stain from work-
ing deeper into the fabric.
A WARNING
Do
not use lacquer thinner, nail polish remover, carbon
tetrachloride, spot remover, gasoline, or naphtha for
any
cleaning purpose. These products may cause
damage to the
material being cleaned, and may be
highly flammable or poisonous.
Solid Surface
Top
Care (If Equipped)
The counter top is constructed
of
a solid sutface
material that requires little care. Routine care
involves wiping the surface with a damp cloth to
remove water marks. For stains, wipe with soapy
water or ammonia-based cleaners. Do not use
abrasive cleansers or steel wool.
Laminate Top Care (If Equipped)
For cleaning laminate surfaces, uses mild dish-
washing liquid with warm water. Use a soft
cloth for both washing and drying.
Do not use abrasive cleaners, steel wool, or gritty
cleaners
or
damage will occur to the surface.
Walls
and
Ceiling Panels
The paneling and the ceiling
of
your motor
home may
be
any
of
several finishes and tex-
tures. Never use harsh detergents or abrasive
cleaners on walls or ceilings. Most surfaces will
clean with a soft cloth moistened with mild
liq-
uid detergent in warm water, or a clear window
cleaner solution. Do not scrub the surface or use
11-3
To Next Page
Loading...
