Engine Access
The top
of
the engine may
be
accessed from
inside the motor home for service by lifting or
removing the engine cover.
A WARNING
The interior engine cover is heavy. Use care when
opening or
closing the cover.
A WARNING
When installing the engine cover,
be
sure the cover is
fully seated
on
the gasket seal and secured by the
clamps.
Do
not allow insulation, carpeting, or other
material
to
interrupt the seal between the cover and
the engine compartment.
If the engine cover is not
installed correctly, engine exhaust gases could leak
into the passenger compartment creating a safety
hazard.
If
the engine must be
run
with the engine
cover off for maintenance purposes, be sure the vehi-
cle interior is adequately ventilated.
EXTERIOR SEALANTS
Consult your Fleetwood Motor Home dealer for
the most current sealant use.
Windshield
Window sealant
Roof sealant
GENERATOR FILTERS
Consult your Fleetwood Motor Home dealer
or
see the GenSet Service
and
Parts
Directory in
your
Owner's Information Package.
Oil Filter
Fuel
Pump Filter
Element Fuel Filter
Maintenance
ACRYLIC ASSIST HANDLES
(If Equipped)
Do not use any cleaners that contain ammonia,
petroleum, ammonia based, or petroleum based
products. Most glass cleaners are ammonia
based. Most tar removers are petroleum based.
Wash
Assembly
with
MILD
SOAP
AND
WATER
ONLY!
Exterior
Interior
WINDSHIELD WIPERS & WASHER
Your motor home is equipped with windshield
wipers that are located on the upper front cap.
Having the proper windshield washer solution
will
be
an important step in maintaining your
system in good operating order.
CAUTION
Use only a windshield washer solution that is rated at
a minimum of -
20 degrees F (-8 deg
C)
to prevent
damage to the system from freezing up.
11-5
To Next Page
Loading...
