Heritage
Information
information are also included on these screens.
The "TODAY" screen is designed to give daily
infonnation.
It
provides miles and time to
scheduled destinations, miles and time traveled,
average
MPG (Miles Per Gallon) and average
MPH (Miles Per Hour).
The
"TODAY" screen
also provides inside and outside temperature
along with compass heading.
The
"LEG" screen purpose is to give trip infor-
mation between fuel tank fills. The
"LEG"
screen displays average MPH and average MPG,
time and miles traveled, gallons used, road
speed, cmise control status and compass head-
ing.
The
"TRIP" screen provides long term trip data
tracking. The
"TRIP" screen provides average
MPH and average MPG, time and miles trav-
eled, gallons used, current
MPG, and compass
heading.
The
"COACH" screen provides engine I trans-
mission performance data and status. The
"COACH" screen displays the gear selected and
gear attained, turbocharger boost pressure,
engine and transmission coolant temperature,
engine oil temperature and pressure, average
MPG and compass heading.
The
"TIRE STATUS" screen provides tire pres-
sure and temperature, pressure deviation, and
alerts when displayed.
The above items are the main and most com-
monly use screens and functions. Additional
information and set -ups can be obtained from
lower level screens. These lower level screen
and functions are listed below:
04-12
CLOCK TIME ZONE
SET COMPASS STATE
MAINTENANCE
SETUP MENU
CONFIGURE TIRE
CUSTOMER SERVICE
Please refer to the TripTek Motor Coach Trip
Computer
Operator's Manual for more detailed
instmctions and descriptions
of
the
TripTekTM
Motor Coach Trip Computer system.
CAMERAS
There are four cameras provided with the sys-
tem. They are: back-up (rear), door side, road
side, and interior. The camera images are dis-
played on the coach dash monitor and on the
optional bedroom monitor. The cameras can be
manually selected by the Video Valet Switch
and camera images can be displayed one at a
time.
The cameras are also automatically selected
when the ignition is in the
"ON" position. There
are three camera functions that automatically
occur based on external activity. The automatic
camera functions are
as
follows:
• Automatically display back-up camera
on the monitor when reverse gear is
selected.
• Automatically display door side camera
on the monitor when right turn signal is
active.
• Automatically display road side camera
on the monitor when left tum signal is
active.
The displaying
of
the back-up camera image
when reverse gear is selected will oven'ide all
other screens including the door and road side
camera images.
When the reverse gear or the right
or
left turn
signals are no longer selected the monitor screen
will return to the previous screen.
VIDEO VALET SWITCH
There will be a "VIDEO VALET" rocker switch
for each monitor. For the front in-dash monitor
the
"VIDEO VALET" rocker switch will
be
on
the gear select panel that is located on the left
hand side
of
the driver.
If
the coach has the
optional bedroom monitor the
"VIDEO
To Next Page
Loading...
