button, the setting screen changes
in the following sequence:
Picture
-+
Brightness
-+
Color
-+
Hue
-+
Video Adjust
-+
Mode
-+
Blue
Back
-+
Select NTSC or PAL
System
-+
Menu Off
When in a display setting screen
use the
"DIMMERI+" or
"INPUT-" to adjust desired set-
ting.
DIMMERI+ Depress and release the
"DIM-
MER"
button to select dimmer
ON /
OFF.
Normally keep the
dimmer in the day
"OFF" mode.
When viewing the picture at
night or in a tunnel, etc., depress
and release the dimmer button
once to make the display less
bright (night mode).
To
return to
day mode depress and release the
dimmer button once.
INPUT/-
Depress and release the
"INPUT/-" button to select the
desired input source,
VIDEO 1 or
VIDEO 2.
NOTE
Video source should always
be
set
to
VIDEO 1
NTSC
The bedroom monitor operates in two modes,
"security" and "drive". When in the"security"
mode the display will scan through the exterior
cameras (back-up, road side, door side) and con-
tinue scanning. When in the
"drive" mode (igni-
tion key
"ON") the user can toggle through the
images for the back-up camera (with TripTek
superimposed), Navigation System, inside cam-
era, door side camera, and road side camera.
There are two ways to enter
"security" mode.
One method is after the ignition has been turned
from
"ON" to "OFF" press and hold the "up"
side
of
the "VIDEO VALET" rocker
Heritage
Information
switch. Once the display image appears release
the switch. The display should now
be
scanning
through the outside cameras.
If
no image
appears assure the display is
"ON". The second
method occurs automatically when there have
been no presses
of
a "VIDEO VALET" rocker
switch for five minutes.
There are also two ways to enter the
"drive"
mode or otherwise stop the scanning. One
method is simply place the ignition key in the
"ON" position. The second method is when the
monitor is in the
"security" mode (scanning),
press either side
of
the "VIDEO VALET" rocker
switch. After the scanning has stopped the
"VIDEO VALET" rocker switch can
be
used to
move up and down through the images.
.II
NOTE I
The information from TripTek will be superimposed on
the back-up camera screen for approximately
90
min-
utes after the ignition
key
has been
set
to
the "OFF"
position.
04-15
To Next Page
Loading...
