AIRCRAFT TROUBLESHOOTING GUIDE (CONTINUED)
22
Unless specically required, ALWAYS troubleshoot the airplane with the propeller removed.
DISCREPANCY
PROBABLE CAUSE
RECOMMENDED SOLUTION
Any of four PWM servo cables not connected
PWM Servo cables connected to incorrect ports
Polarity of PWM Servo cables not correct
Receiver not bound and/or outpung PWM
servo pulses
Connect all four male to male servo cables between your receiver and Aura
Re-connect cables to proper ports. Reference chart on page 11
Remove servo cables and connect with proper polarity (reference page 11)
Bind your receiver per your manufacturer's instrucons, and use a servo
ensure it is outpung PWM signal from all four channels required
PWM Connecon type and
cannot get Orange+Green
Aura LED and Control of
Model
Airplane Rolls when aps are
in the down posion
Le and right ap travels are not equal
Adjust servo arm locaon on spline and/or ap pushrod length to match
throws. Reference Cessna 170 wiki page for more informaon:
hp://www.wiki.exinnovaons.com/Cessna170
To Next Page
Loading...
