Flex L 8-11 115 User Manual

L 8-11 115 / L 8-11 125 / LE 9-11 125
21
 Press and hold down the spindle lock.
 Tighten the clamping nut with the face
spanner.
 Carry out a test run to check that the tool
is clamped in the centre.
Test run
 Insert the mains plug into the socket.
 Switch on the angle grinder with the
switch (without engaging it) and run the
angle grinder for approx. 30 seconds.
Check for imbalances and vibrations.
 Switch off the angle grinder.
Switching on and off
Brief operation without engaged switch
rocker
 Push the switch rocker forwards and
hold in position.
 To switch off the power tool, release
the switch rocker.
Continuous operation with engaged
switch rocker
 Push the switch rocker forwards (1.) and
engage by pressing the front end (2.).
 To switch off the power tool, release
the switch rocker by pressing the rear
end.
NOTE
Following a power failure, the switched on
power tool does not restart.
Preselecting the speed
(only LE 9-11 125)
To set the operating speed, move the dial
to the required value.
CAUTION!
Risk of injury due to destruction of the tool.
Use the appropriate tool for the job.
NOTE
If an overload or overheating occurs during
continues operation, the power tool auto-
matically reduces the speed until the power
tool has cooled down adequately.

Flex L 8-11 115 Specifications

General

Spindle thread	M14
Idle speed (max)	11500 RPM
Grinding disc diameter	115 mm
Input power	800 W
Cable length	4 m
Output power	450 W
Power source	AC
Product color	Black, Red

Weight and Dimensions

Weight	2000 g